General Grinding Wheel

We specialized in making vitrified and resinoid grinding wheels with the diameter of 3~1250mm and thickness of 400mm. Such as for cylindrical grinding, surface grinding, centerless grinding, ball-bearing grinding, thread grinding, slideway grinding, gear grinding, tools grinding, and roll grinding as well as cut-off wheels and resinoid grinding wheels.

Type of bond
1. Vitrified Bond
It features high strength and certain of elasticity and excellent self-sharpening performance, low heat-resistance, short production lead.
2. Resin Bond
Higher combined strength, good flexibility. Working in the high speed, good self-sharp capability.
3. Rubber Bond
High strength, good flexibility. Closed structure in the wheel. Low air hole rate, working with the high speed.

Safe Usage:
1. Before starting the lathe, check the protection cover and the switches for various action to observe whether they can be adjusted to the place where they should reach and whether they have been fixed well.
2. The protection cover should cover at least half of the wheels.
3. After the wheels are installed onto the main axle of the lathe, they should race for at least 5 minutes.
4. The surface on both sides of the grinding wheels cannot be used for grinding unless the wheels are made on the purpose.
5. When in use, it is prohibited to push the work piece with lever to increase pressure on grinding wheels.
6. When processing of repairing the grinding wheels, penetrate the cutting tool properly. Repair and maintain grinding wheels with special tools.
7. Close cooling liquids before the wheels stop to avoid bad influence on the static balance.
8. It is prohibited to use grinding liquids destructive to the bonds of grinding wheels.