Typical Electromechanical Installation and Control Trainer

1.  This trainer adopts sectional structure andcontains AC servo motor and driver, stepper motor and driver, DC brushlessmotor and driver, AC motor and frequency converter regulating unit, touchscreen unit, PLC and A/D, D/A unit, sensor and rotary encoder unit, beltconveyor unit, ball screw unit, worm and gear unit and so on. All interfacesare open type, which is convenient for operation.

2.  It is suitable for teaching and training suchas electromechanical equipment installation and maintenance, electromechanicaltechnology application, electrical operation and control, etc.

3.  Safety protections: grounded, leadprotection, safety in accordance with related standards. Insulated safety sockets,sheathed cables and wires.

> EXPERIMENTS

1.  Touch screen control

2.  Basic commands programming

3.  Advanced commands programming

4.  PID control commands programming

5.  Three-phase asynchronous motor frequency control

6.  Stepper motor start control

7.  Servo motor speed and positioning control

8.  Brushless DC motor speed control

9.  Various sensors and encoder application

10.Integrated control of belt conveyor unit

11.Integrated control of lead screw drive

12.PLC communication control

13.Frequency converter control

> TECHNICALPARAMETERS

1.  Input Voltage : AC 380V, 50Hz

2.  Temperature : -10~50oC, Below RH 90%

3.  Overall power consumption: ≤1.5kVA

4.  Dimensions: length × width × height = 1200mm× 800mm × 1050mm